Do you have a newly acquired tent Vango Tempest 200? If so, you may be interested to learn how to transfer it. In fact, this should not be a problem. Here are a few pitching instructions that you can use so that you can easily and properly set up a Vango tent. This guide is very simple and not difficult to follow, so do not think that it will be a difficult task how to do it.
First sheet lift
The first thing you need to do when creating a Vango Tempest 200 tent is to collect the poles of the tent and place them in alignment with the ground. These poles are the supports of long, medium and short alloys. The next step is to unfasten the flash list and correctly place it on the ground. Check the tensioning belts if they are already disconnected from each other. Choose the direction you want and make your tent there. After that you should look into the outer part of the sheet, and then find the pins. Once you do this, insert the middle and long poles into it. After that you should put a short pole and place it in the lugs. Find the tip of each main pole and place it on its designed eyelet, located on the anchor belts of the pole.
Start on one side of the tent. The poles must be shifted so that they look like arcs. The ends of the poles must be placed on their designated lugs that are located on the pole support belts. You must ensure that the tensioning belts are tight. Attach anchor straps to the back of the tent with the included accessories. To see the full shape of the tent, you must draw a sheet in the opposite direction from the attached points. The latter mounts should be used when attaching anchor belts that can be found in the front. Then the poles must be connected to the clips of the flash list. Make sure that no anchor belts are attached to each other, and as soon as you finish this, you must attach all the lines of the guy.
Setting up the inner tent
First of all, you must unfasten the inner tent of the Vango Tempest 200, which can be found in the elevator. The door should be placed in the direction corresponding to the entrance to the porch. Start at the back of the Vango tent and connect the sheets and hooks with their designated rings, which are located on the flash-leaf anchor belts. After this, you must now connect the inner hooks of the tent to the inner rings of the weavers. As a final step in this procedure, place the attachment and the mounted porch.
Tensioning system
Remove the strip system from the pockets. Attach it to the indicated sockets at the top of each pole. Make adjustments until the belts are tight. Ensure that the TBS rear straps are intertwined on the inside. access points. It is strongly recommended that you be too tense to not transfer to the tent to prevent distortion of the poles.
There you have your new tent fully configured. Now just put your sleeping things in and start enjoying the campsites.
